Nexo DTDAMP4X1.3C Power Amplifier
DTDAMP4X1.3C
Usually shipped within 2-3 working days
The Nexo DTDAMP4X1.3C Power Amplifier is ideal for powering mobile or fixed installations of NEXO ID and PS Series systems, the 4-channel, 1U rack-mounting DTDAMP is available in two versions: 4 x 700 Watts and 4 x 1300 Watts (4 x 4 Ohms).
The DTDAMP partners perfectly with the touring and install versions of the DTD Controller to create a compact, light-weight, intelligent powering solution that’s easy to configure – either in a ‘dry hire’ application where the user has limited knowledge, or in a fixed installation such as a bar or club.
FEATURES:
- Two models of high-power, lightweight four channel amplifiers
- Perfect match for the NEXO speakers supported by the DTD Controller
- High-efficiency Switch Mode power supply and Amplifier channel design
- Channels can be independently bridged two by two
- Four Inputs on XLR connectors and four Outputs on SP-4 connectors
- Extensive protection (Mains over/undervoltage, temperature, DC outputs, current and voltage peak limiters, variable speed cooling system)
SPECIFICATION:
Power
- Number of channels:4 x amplifiers channel, 2 by 2 bridgeable
- Max. output voltage (no Load): 4 x 135 Volts
- Max. output power (4 x 8 Ohms): 4 x 750 Watts
- Max. output power (4 x 4 Ohms): 4 x 1300 Watts
- Max. output power (2 brigde x 8 Ohms): 4 x 2600 Watts
Audio Characteristics
- Frequency response: +/- 0.5 dB from 20 Hz to 20 kHz
- Input impedance: 10 kOhms
- Input sensitivity: +8 dBU
- Nominal Gain: 32 dB
- Dynamic Range (A-weighted): > 110 dB
- THD+N: Typical 0.01%
Back Panel Features
- Analog audio inputs: 4 x balanced analog inputs on XLR
- Power outputs: 4 x SP4 outputs
- Link switch: To use same XLR input for 2 x adjacent channels
- Mains sockets: IEC C14 Inlet with secure lock
Front Panel Features
- Switch and knobs: Mains On/Off switch and volume control knob per channel
- View meters: 4 x LEDs (signal / -18 dB / -6 dB / Peak) per channel
- Amplifier status: Amp Ready and Temperature indicator per channels pairs
Mains Requirements
- Mains voltage: Factory set for 120 volts of 230 volts mains operation
- Power consumption (Idle): 65 Watts
- Power consumption 1/8 max. / 4 Ohms: 900 Watts
- Power consumption 1/4 max. / 4 Ohms: 1800 Watts
Physical Specifications
- Dimensions (W x H x D): 480 (W) x 44 (H) x 370 (D) mm, 19 inches / 1U
- Weight: 7.5 kg
- Operating temperature range: 0°C - 45 °C
Certifications
- CE conformity: 2006/95/CE (Low voltage) 2004/108/CE (EMC) 2002/95/CE (RoHS)
- Electrical safety certification: CSA, CB, EN60065
- EMC certification: EN55103-1 / EN55103-2 / FCC
Ordering Information
- Pre-configured for 230 volts mains: DTDAMP4x1.3C
- Pre-configured for 120 volts mains: DTDAMP4x1.3U
Manufacturer: Nexo