Manley MicMAID

The MicMaid Microphone Preamp matrix-switcher saves precious studio time and dramatically increases efficiency by allowing for “live” audition of up to four mics and four preamps in any combination.

With its convenient level-matching capabilities, user-programmable routing schemes, and thoughtful monitor features, the best mic/mic preamp combination for every session can be instantly chosen. Any mic, any preamp, any time.

FEATURES:

• FOUR Microphones A/B/C/D matrix to FOUR external Microphone preamplifiers 1/2/3/4
• LOCK each selection combination for comparison
• Front-panel 1/4" Direct Input with Variable Phase circuit and Ground Lift switch
• THRU: mirrored output of the Direct Input
• Low/High range select for Variable Phase all-pass filter
• Remote Fader jack for manual gain riding
• Polarity Switch flips phase 180degrees for selected Matrix path
• MONITOR SECTION has ±19.5 dB gain trim for each signal path
• STORE and RECALL settings for gain, mic & pre combinations
• Phantom Power selection for each microphone A/B/C/D
• DIRECT OUTPUT provided for each micpreamp return
• Pickle Remote can step through each microphone or each preamplfier for "sweet spot" selection
• Variable illumination brightness user-selectable in three levels
• High-quality, gold-contact sealed relays used throughout
• Neutrik gold-contact XLR jacks
• FOUR Microphones A/B/C/D matrix to FOUR external Microphone preamplifiers 1/2/3/4
• LOCK each selection combination for comparison
• Front-panel 1/4" Direct Input with Variable Phase circuit and Ground Lift switch
• THRU: mirrored output of the Direct Input
• Low/High range select for Variable Phase all-pass filter
• Remote Fader jack for manual gain riding
• Polarity Switch flips phase 180degrees for selected Matrix path
• MONITOR SECTION has ±19.5 dB gain trim for each signal path
• STORE and RECALL settings for gain, mic & pre combinations
• Phantom Power selection for each microphone A/B/C/D
• DIRECT OUTPUT provided for each micpreamp return
• Pickle Remote can step through each microphone or each preamplfier for "sweet spot" selection
• Variable illumination brightness user-selectable in three levels
• High-quality, gold-contact sealed relays used throughout
• Neutrik gold-contact XLR jacks

SPECIFICATION: 

INSTRUMENT INPUT:

• Input Impedance: ≈ 120K Ohms
• Gain Ratio: 12:1 Step down.
• Voltage Gain: -22 dB (Signal Source: Sine 1 kHz, +4dBu, 6K8 Ohm Source Impedance, 1K Ohm secondary load impedance)

ROUTING MATRIX:

• Matrix Crosstalk:
• Leakage from adjacent microphone inputs: ≥ 117 dB (1 kHz sine)
• Leakage from adjacent Preamp sends: ≥ 107 dB (1 kHz Sine)
• Microphone Inputs terminated with source Z=150 Ohm, Preamps sends terminated with 2K7 Ohm load

MONITOR/RECORD OUTPUT:

• Gain: ±19.5 dB (.5 db steps)
• Frequency response: ±.5 db 10 Hz- 100 kHz
• Outputs: XLR Electronically Balanced
• Output Impedance: 66 Ohms
• Max Output Level: +28dbu into 100K load @ .025% THD+ NOISE
• Distortion: 0.003% THD+NOISE
• Bandwidth: 22 Hz - 22 kHz, Unity gain, into 100K Ohm load
• Noise Floor: -90dbu A-weighted
• Dynamic Range: 118 db
• ICMMR: ≥ 86 dB (1 kHz sine, 50mV input)
• Note: Mon/Rec active stage ALWAYS "looks" at selected PREAMP as its signal source.

DIMENSIONS AND POWER:

• Power Consumption Idle: 12 watts 0.1 Amp @ 120V
• Power Consumption Maximum: 20 watts 0.17 Amp @ 120V
• Mains Fuse: 500mA @ 100~120VAC; 250mA @ 220 ~ 240VAC
• Mains Fuse type: 5mm x 20mm SLO-BLO GDC glass fuse, 250V AC rating
• NOTE: Operating mains voltage: Units are purpose built for original destination country's mains voltage: 100V, 120V, or 220-240VAC as indicated on the serial number badge. The power transformer in this unit must be rewired in order to change mains operating voltage.
• Unit Size:19" x 10" x 3.5" (occupies 2u)
• Unit Weight: xx lbs.
• Shipping Weight: 19 dim. (international); 17 lbs. (USA)
• Shipping Box Dimensions: 23" x 15" x 9"

Manufacturer: Manley